Rorke Data The Galaxy 65 Especificaciones descargar pdf (Pagina 79)

Chapter 5: Subsystem Maintenance and Upgrading

Replacing a Failed PSU Module

5-13

Figure 5-9: Remove the Cooling Module

Step 7. Reinstall the cooling module into the new PSU module: To do this,

align the cooling module with the lower level of the PSU bracket and

gently slide the cooling module in.

Step 8. Insert the new PSU module into the subsystem: Once the previously

removed cooling module has been installed, insert the new PSU

module into the subsystem. Make sure the extraction lever is in its

downright position so that the saddle notches on the lower edges of

the handle can lock on to the edge metal brackets along the chassis

inner walls. Push the PSU into the slot and pull the handle upwards to

secure the module.

Step 9. Reinsert the retention screw: If the PSU module is properly installed,

the back end of the module should be aligned with the enclosure’s rear

panel. To firmly secure the PSUs into place, reinsert the retention

screw.

Step 10. Reconnect the power cord and turn the power on: Plug the power

cord into the socket on the PSU module and turn the PSU module

power switch on.

1 2 ... 74 75 76 77 78 79 80 81 82 83 84 ... 99 100

Sin comentarios

Rorke Data The Galaxy 65 Especificaciones Pagina 79